|
W i r e d R e m o
t e s |
|
  |
|
DT-ST-CAMEYE16
CamEye Sport LANC 1.6 Version
remote control Designed for use in extreme sports together with a
"bullet" type camera lens connected to your video recording device
(video camera with AV in capability or video recording deck).
$58.99 |
|
|
OUT OF STOCK |
|
LANC-EXT-1M
3 ft (1m) Extension cable for the wired CamEye
Sport LANC remote control (DT-ST-CAMEYE16)
$7.55 |
|
|
|
CAM-23, E23, or CAM-35
Remote Controller
|
|
|
Microphones
|
|
Modular Microphone w/ 4-pin positive lock waterproof connector
 |
|
DT-MIC-1 Hi-Gain
+9 to 14VDC omni-directional two channel
microphone. Features the all-new Datatoys 4-pin locking modular wiring found in DT-CAME380, DT-CAME560 and
DT-CAME580 cameras and XM-DVR solid state mpeg2 digital video recorder
line. Only $24.99 |
|
Hook-up wiring
compatibility:
Modular 4 pin connector for DT-CAME 580,
DT-CAME560 and DT-CAME380 series of Sony CCD Helmet Cam Bullet Cameras and XM-DVR
MPEG2 Solid state DVR
|
|
|
Powered Microphone w/ 12V power
pass-through
 |
|
9750-125 Hi-Gain +12VDC
omni-directional two channel microphone.
Only $24.99 |
|
Hook-up wiring
compatibility: RCA for older
"standard" cameras
|
|
|
Back to Top |
|
P o w e r A d a p t
e r s |
Power Converter, +12V DC
|
|
DC-12V-800MA-1
/ P/N 9750-160
12V DC-DC regulated DC-DC converter
provides clean
power for DataToys CAM23, CAM35, CAME380 or CAME580 helmet
cameras and MultiView-2 XG Picture in Picture Video Processor. Regulated
Power with Fuse installed in the cig plug.
REGULATED POWER / FUSED. $29.99 |
|
|
Automotive "Lighter Plug" Power Adapter, +12V DC
 |
|
DC-12V-ACC-1
/ P/N 9750
12V DC-DC automotive power adapter,
fused, with power indicator light. Single 2.1mm x 5.5mm female
power output will connect to a single DataToys CAM23 helmet camera and DataToys powered Microphone MIC-1, CAM35
bullet camera, or our MultiView-2 video
processor. 6" 18AWG wire, 5A Fuse, power LED.
NOT REGULATED. $12.99 |
|
|
|
Back to Top |
|
B a t t e r y P a c
k s |
DC 12 Volt 3500mAH NiMH Battery Pack with Charger
|
(8) AA / 12 Volt Covered Battery Holder
features 2.1 mm x 5.5 mm Female Plug with strain
relief
both sides covered by ez-glide doors
(8) AA Batteries not included
|
|
Back to Top |
|
C a m e r a M o u n
t s |
Universal
Mini-Mount Camera Mounting System
with Ball Head for Bullet Camera or Helmet Camera
|
Super Mount (tm) Camera Mounting System
|
AutoXMount(tm)
Suction Mounting System
Suction mount used to support small camcorder
or a helmet/bullet camera where permanent installation does not make sense
DT-AX-MNT-1 AutoCross Suction Mount, "single cup"
DT-AX-MNT-1 pictured with
DT-CAM-23 bullet camera attached.
DT-CAM-23 not included.
|
|
Back to Top |
|
L e n s e s &
L e n s A c c e s o r i e s |
|
|
|
|
|
|
CAME series clear "OE" protective glass cover, 3 PACK |
|
DT-LEN-CVR3PK $7.95 |
|
|
|
CAME Series Lens Cover rubber "OE" O-Ring Seal, Waterproof, 3 PACK |
|
DT-LEN-ORING3PK $7.95 |
Keep your CAME series of Extreme Helmet cameras operating at 110%. If you have damaged lens cover glass, and you have had the camera for a season - be sure to replace the rubber o-ring seal. Cheap insurance to keep your helmet cam operating without failure due to a worn or damaged rubber seal. Your videos will remain crystal clear while the lens itself is fully protected. This is not "replacement" o-ring by 3rd party. The fit is not "close enough" - it is 100% correct. This is the same rubber o-ring seal that gets installed into our CAME product line. Leave nothing to chance - use original equipment and spare parts.. |
|
|
Back to Top
|
